Kleenmaid DW27i - Manual (Page 5)

• 5 •
Fitting the door panel :
There are two ways of fitting the front of your
machine :
1 - A cabinet door + false drawer
2 - A complete front panel
Consult page 13 of this manual for this
operation and use the assembly template and
accessories supplied with your machine.
Adjust the springs to set the door, see Fig. 15.
You will find this easier with the door closed.
Important : This machine best operates
equipped with door panels.
Plumbing :
1 . Water Connection
• This Kleenmaid “Super Silent System”
Dishwasher can be connected to cold water or
hot water not exceeding 65 °C.
• We recommend that the Dishwasher is
connected to a cold water supply.
NOTE : Connection to a hot water supply will
change the length of the wash cycles
and can reduce the drying efficiency of
the dishwasher.
2 . Water Supply (Fig. 2)
a . The water supply to the Dishwasher should
not be less than 12 mm domestic water pipe.
A readily accessible tap must be installed in
the supply pipe.
b . The inlet connection hose supplied is fitted
to a 3/4" BSP male thread, which must have
an adequate sealing face for the washers
supplied.
c . If the Dishwasher is connected to a hot water
supply, then the water temperature at the
Dishwasher must never exceed 65 °C.
d . The water supply pressure is to be between
0.2 MPa (3.0 psi) minimum and 0.7 MPa
(100 psi) maximum.
If pressure is greater 100 psi, it is recommended
to fit a pressure limiting valve to prevent
damage from rises and increased pressure of
peak demand.
INSTALLATION
IMPORTANT ! :KLEENMAID RECOMMENDS THAT
YOUR DISHWASHER BE INSTALLED BY AN
AUTHORISED Kleenmaid INSTALLER OR SERVICE
AGENT !!
Before you start :
1 . These instructions are intended as a guide
only. It is the responsibility of the Plumber and
Electrician to ensure that each installation
complies with local by-laws.
2 . Connection to cold water is recommended.
3 . This Dishwasher must not be connected to a
water supply where the temperature of the
water exceeds 65 °C. If this Dishwasher is to be
connected to a system where there is no
temperature control, a temperature control
valve, limiting the water temperature must be
fitted.
4 . When installing the Dishwasher, check that
the drain hose does not become restricted or
kinked.
Levelling : Adjusting the feet :
Make sure that the machine is properly upright
and stable. The four feet may be altered, adjust
them if necessary using a wrench or a
screwdriver. Badly adjusted feet may move the
door off centre and make the machine unstable.
Poor adjustment of the levelling feet can cause
the dishwasher to leak.
IMPORTANT : Do not connect the dishwasher to
the power or water supply before completing
installation.
If you are installing your dishwasher on carpet,
adjust the feet so that you leave space for air to
circulate underneath the machine.
Fitting your machine into your kitchen :
The building in sizes for the machine are given in
the “technical characteristics” chapter on
page 13.
Glue the steam protector supplied with your
machine underneath your worktop.
To maintain stability and proper alignment, you
should attach your machine to the work surface
using a bracket.