Kleenmaid DW15W - Manual (Page 5)

• 5 •
IMPORTANT ! : KLEENMAID RECOMMENDS
THAT YOUR DISHWASHER BE INSTALLED BY AN
AUTHORISED KLEENMAID INSTALLER OR
SERVICE AGENT !!
Before you start :
1 . These instructions are intended as a guide
only. It is the responsibility of the Plumber
and Electrician to ensure that each
installation complies with local by-laws.
2 . Connection to cold water is recommended.
3 . When installing the Dishwasher, check that
the drain hose does not become restricted or
kinked.
Levelling : Adjusting the feet (Fig. 4) :
Make sure that the machine is properly upright
and stable. The four feet may be altered, adjust
them if necessary using a wrench or a
screwdriver. Badly adjusted feet may move the
door off centre and make the machine
unstable.
IMPORTANT : Do not connect the dishwasher to
the power or water supply before completing
installation.
If you are installing your dishwasher on carpet,
adjust the feet so that you leave space for air to
circulate underneath the machine.
Fitting your machine into your kitchen :
The building in sizes for the machine are given
in the “technical characteristics” chapter on
page 11.
Plumbing :
. Water Supply (Fig. 2)
a . The water supply to the Dishwasher should
not be less than 12 mm domestic water pipe.
A readily accessible tap must be installed in
the supply pipe.
b . The inlet connection hose supplied is fitted
to a 3/4" BSP male thread, which must have
an adequate sealing face for the washers
supplied.
c . The water supply pressure is to be between
21 kPa (4.0 psi) minimum and 970 kPa
(140 psi) maximum.
If pressure is greater 100 psi, it is recommended
to fit a pressure limiting valve to prevent
damage from rises and increased pressure of
peak demand.
Evacuating waste water (Fig. 3)
Connect the waste pipe
A. Either to the ventilated siphon. The waste
pipe must be free in the siphon and should
be no deeper than 20 cm.
B. Or on the sink siphon. Be careful not to
forget to remove the siphon cover.
Be careful to fix the waste pipe down with a tie
to avoid any flooding. In any case, the end of
the pipe must be between 60 cm and 1 m high.
Avoid folding the pipe when installing.
- Horizontal drain lines should not exceed 5 m
length.
- Ensure that the drain hose is fully extended
and not restricted in any way.
NOTE : Do not connect drain hose directly
to a waste disposal unit as blocking with
food waste will occur.
Connecting to the power supply :
You should use an earthed plug to connect to
the power supply. In case of a direct connection,
the main switch terminal should be at least
3 mm apart.
The electric plug should remain accessible. Do
not use an extension lead or multiple plug.
• We cannot be held responsible for any
incident caused by the machine being badly
earthed.
In any case, the machine must be fitted in
compliance with the applicable regulations in
your state as well as any extra instructions from
the Electricity Company. The machine’s approval
INSTALLATION