Sirio 827 - Manual (Page 2)

B
Copyright SIRIO antenne - Technical Data are subjected to change - Printed in ITALY - Rev. 16/10/2008 - Cod. ID082
Freq. (MHz)
26.4
27.0
(Ch.19 CB) 27.185
27.5
28.0
28.4
L (mm)
670
457
400
300
137
18
TUNING TABLE TUNING TABLE
1 1 2 2
HI-QUALITY ANTENNAS MADE IN ITALY
Pull out the sections of telescopic aluminium
whip (1) and lock they using the screws (2).
Insert the top aluminium tube (3) at L (see
tuning table for frequency) and lock it using the
screw (4) and 2 mm hexagonal key (5).
Mount the PVC cap (6).
NOTE: Use the table just as a guide. For fine-
tuning please use an SWR-meter
Insert the PVC cap (6) on
the tubes (11). Insert the
brass reinforce (12) in the
tubes (11) and lock they
using the screws (13) and
3mm hexagonal key (14).
Assemble the fixing ring
(15), the screws (16) and
the nuts (17) in according
to the picture and mount
the antenna on the mast.
Fit the whip (1) on
the tube (7) using the
hose clamp (8).
Mount the tube (7)
on the bottom part
with coil (9) and lock
it using the hose
clamp (10).
Mast Æ 35-39mm
(not supplied)
Parts List
Pos Q.ty Description
1 1 4 sections telescopic aluminium whip
2 6 Æ 3.9x6.5 phillips tapping screws
3 1 Æ 6x8x700mm top section tube
4 1 M4x4 hexagon socket set screws cup point
5 1 2mm hexagonal key
6 9 PVC caps for Æ 8 mm aluminium tube
7 1 Æ 33.5x37x1100 mm aluminium tube
8 1 Æ 32-35 mm hose clamp
9 1 Bottom section assembled with coil and connector
10 1 Æ 40-43 mm hose clamp
11 8 Æ 6x8x1400mm aluminium tubes
12 8 brass radials reinforces
13 8 M6x6 hexagon socket set screws cup point
14 1 3mm hexagonal key
15 2 AISI 302 stainless steel rings
16 4 M8x30 exagon head screws
17 4 M8 square nuts
n. 1 tape rules (meter)
n. 1 phillips screwdriver
n. 1 10 mm open key
n. 1 13 mm open key
Mounting needed tools:
Insert limit
punching
4
S
E
C
T
IO
N
S
A
L
U
M
IN
IU
M
W
H
IP
Æ 6x8x700mm
top section tube