Koga E-BIKE ION - Manual (Page 15)

64
1.4.3 Safety
The battery pack can only be used on the bicycle on which it has been
installed. A code in the software makes sure that it cannot be used on
another bicycle, that is to say, there will be no peddling assistance
(protection against theft).
1.4.4 Peddling assistance
You can switch on the system by pressing the up arrow on the lights
button. When the E-bike is not being used, the peddling assistance and
lights will be switched off automatically after five minutes. The display will
be put in the sleep mode automatically after another five minutes and the
display will no longer be shown.
Press the up arrow on the lights button to cancel the sleep mode. The
sleep mode of the display will also be cancelled when the bicycle is again
in motion.
1.4.5 Diagnosis report
If all LEDs flash on the battery pack, first
check whether the battery pack (A) has
been correctly connected to the docking
station (B).
If the LEDs continue to flash, contact your
dealer.
1.4.6 Lighting
The lights (both at the front and rear) are supplied with electricity by the
battery pack and will, therefore, only work when the battery pack has been
installed in the E-bike. The motor will work as a dynamo when the battery
pack is flat.