La Crosse Technology WS-9118U - Manual (Page 12)

12
V. MOON PHASE
There are 12 moon phases shown on the indoor weather station. Thus, when the moon icon is all white, it is a full moon.
New Moon Full Moon
Small Waxing Crescent Large Waning Gibbous
Large Waxing Crescent
Small Waning Gibbous
First Quarter Last Quarter
Small Waxing Gibbous Large Waning Crescent
Large Waxing Gibbous Small Waning Crescent
VI.
TIME ALARM
To set the time alarm:
1. Press and hold the ALM/+ button for 3 seconds.
2. The alarm time will begin to flash in the DATE LCD.
3. Press and release the IN/HR button to adjust the hour.
Note: When in the 12-hour mode and setting an alarm for a time between noon and midnight, “PM” will appear
to the left of the alarm time in the DATE LCD.
4. Press and release the OUT/MIN button to adjust the minutes.
5. Press and release the SNOOZE/CH button to confirm the setting or wait for 15 seconds and the display will
automatically return to the normal mode.
To activate the alarm:
1. Press and release the ALM/+ button to toggle between the alarm time and the day and date.
2. When the alarm time and alarm icon are showing in the DATE LCD the alarm is activated.
3. When the day and date are showing in the DATE LCD the alarm is deactivated.
To activate the snooze:
1. While the alarm is sounding press and release the SNOOZE/CH button.
2. The snooze will be activated and the alarm will come back on after the selected time period.
VII. ADDING REMOTE TEMPERATURE/HUMIDITY SENSORS (OPTIONAL)
The WS-9118U is able to receive signals from 3 different remote temperature/humidity sensors. The remote
temperature/humidity sensor model(s) that you choose will come with their own set of instructions—follow these
instructions for a complete guide to setting up. Following are some brief instructions for the basic set-up of remote
temperature/humidity sensor units with the WS-9118U. These extra sensors can be purchased through the same dealer as
this unit, or by contacting La Crosse Technology directly. A TX4U will monitor temperature and humidity, a TX6U will
monitor temperature only, a TX3U will monitor temperature and display the temperature on its LCD, and the TX3UP
will monitor the temperature via a probe for use in pools, spas, etc.
Note: When setting up multiple units it is important to remove the batteries from all existing units in operation, then to
insert batteries first into all the remote temperature sensor units. Wait until the first sensor reception is received by the
indoor weather station before inserting batteries into the next sensor and so forth. After all the sensors reception is
received, install batteries into the indoor weather station. Transmission problems will arise if this is not done correctly
and if the total time for set-up exceeds 4 minutes.
A. SET-UP OF MULTIPLE UNITS
1. It is necessary to remove the batteries from all units currently in operation.
2. Remove the battery covers to all remote temperature/humidity sensor units.
3. Place all remote temperature/humidity sensor units in a numeric sequential order.
4. In sequential order, install batteries (follow the same battery installation procedures seen in section I. A) of
the Detailed Set-Up Guide).
5. Install batteries into the indoor weather station.
6. Follow the Detailed Set-Up Guide for programming and operating instructions.