LD Systems MEI 1000 G2 - Manual (Page 13)

13
IT
ALIANO
POLSKI
ESP
AÑOL
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
FRANCAIS
DEUTSCH
ENGLISH
1
2
SYSTEM SETUp:
STEREO MODE
Select the stereo mode for the transmission of a stereo-
phonic audio signal.
Press the SET button repeatedly until "FO OFF" or "FO ON"
appears in the display and flashes. Using the buttons,
you can now activate the stereo mode (FO OFF).
In stereo mode, the two input signals of the transmitter
can be heard through headphones (on the left and right)
connected to the receiver
On the receiver, the balance between the two input signals
can be set with the help of the buttons. A total of 31
levels are available : using the button, the centre location
of a stereo signal can be changed by 15 levels to the right
(1-, 2-, 3-, 4-, 5-, 6-, 7-, 8-, 9-, A-, b-, C-, d-, E-, F-) and
by 15 levels to the left (-1, -2, -3, -4, -5, -6, -7, -8, -9, -A, -b,
-C, -d, -E, -F). To bring the centre location of a stereophonic
audio signal to the centre of the stereo base, please select
the -0- setting. To ensure the transmission of a stereo
audio signal in the stereo mode, both the transmitter and
the receiver have to be in stereo mode and an audio signal
has to be present at the INPUT LEFT and RIGHT entrances.
When the transmitter is in mono mode, only the audio signal
(INPUT RIGHT) is being transferred.
1 2
+
RECEIVER PROGRAMMING: