Legrand EFB610CTBK - Manual

Evolution ™ Series Floor Boxes
Activation Covers
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 008 980R1 – Updated March 2012
Legrand/Wiremold electrical systems conform to and should be
properly grounded in compliance with requirements of the current
National Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Legrand/Wiremold electrical
products may bear the mark of a Nationally Recognized Testing
Laboratory (NRTL) and should be installed in conformance with current
local and/or the National Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
Products Covered:
1. PREPARATION: Before installing cover, repair any
cracks or chips around the preset or floor box opening
using a suitable grout or repair compound.
2. EFB610CTC, EFB610BTC Series – Flanged Carpet
Installation Cut opening in carpet as indicated in illustration.
12 1/8"
[308mm]
16 1/8"
[410mm]
TRIM FLANGE INSTALLATION:
3. INSTALLING GASKET (Carpet Installation):
Place gasket onto the underside of the trim
ring as shown. Ensure that gaskets make a
continuous seal around the trim ring.
3a. Flanged Carpet Installation: Installation view of
gasket and carpet.
Carpet Gasket
(compressed)
Flange Carpet
EFB610CT EFB610BT EFB610CTC EFB610BTC
Flat
Gasket
CAUTION: Do not operate floor scrubbers, tile strippers, or resurfacing equipment over the top of the cover. This may result in damage
to the surface of the product.
CAUTION: Wash covers with a mild soap solution. Avoid any cleaning solutions with ingredients that may react with the aluminum
construction of the products.