Legrand 2HUB - Manual

2HUB
2-Inch Conduit Hub Fitting
I N S T A L L A T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 010 592 – February 2012
Legrand/Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Legrand/Wiremold electrical
products may bear the mark of a Nationally Recognized Testing
Laboratory (NRTL) and should be installed in conformance with current
local and/or the National Electrical Code.
IMPORTANT: Please read all instructions
before beginning.
PRODUCTS COVERED: Floor Box Conduit Fitting Cat. No. 2HUB
Plastic Throat Bushing
(included)
Step 1. Remove existing plate and #10-32 x 1/4" hex
screws from side of RFB4E floor box.
Step 2. Position gasket between 2-inch conduit hub
fitting and floor box and mount conduit hub
fitting with (4) #10-32 x 7/16 in. screws
provided.Tighten screws to 2 ft-lbs. (3 N-m).
CAUTION: Ensure plastic throat bushing
is inserted in place in front of
conduit thread