Legrand RC7AM2TCBK - Manual

RC9AM2TC & RC7AM2TC
Poke-Thru Series
INSTALLATION INSTRUCTIONS
Installation Instruction No.: 1 003 168 – June 2003
Step 1 Layout and locate position of hole(s).
Step 3 Core drill hole. Step 4 Stem Assembly. Catalog Nos. RC9AM2STC.
Insert Stem into Hole.
Step 2 Remove 6 1/2" [165mm] section from carpet or tile.
Use template provided.
CAUTION: Holes shall be spaced a minimum of 2' [610mm] on
center and not more than one hole per each 65 sq. ft.
[6 sq.m] of floor area in each span.
Push Down
CAUTION: Be certain to drill hole at least 4" [102mm]
from any wall or pillar to leave enough
room for Poke-Thru cover assembly.
NOTE: For tile thickness greater than 3/4" [19.1mm]
consult factory.
CAUTION: Poke-Thru device cannot be rotated
in hole after insertion into floor.
Walker ® electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
All electrical products may present a possible shock or fire
hazard if improperly installed or used. Walker electrical products
may bear the mark as UL Listed and/or Classified and should
be installed in conformance with current local and/or the National
Electrical Code.
Products Covered: Cat. No. RC9AM2TC, RC7AM2TC, RC9AM2STC, RC9CM2TC, RC7CFFTC
CAUTION: DO NOT operate tile stripper or resurfacing equipment over top of covers.This may result in damage to the surface finish
of the product.
IMPORTANT: Please read all instructions
before beginning.
24" [610mm] Min
Center – Center
6 1/2"
[165mm] Diameter
3" Diameter Core Drill
3 1/16" [78mm] Actual Diameter