Legrand RC3 Replacement Scrub Water Cover Assembly Kit - Manual

IMPORTANT – PLEASE READ ALL INSTRUCTIONS BEFORE BEGINNING.
Products Covered: RC3KTC
CAUTION: Do Not operate tile stripper or resurfacing equipment over top of covers.
This may result in damage to the surface finish of the product.
Step 1. Remove junction box cover and disconnect wires. Step 2. Remove slide holder.
CAUTION: De-energize circuit before removing junction box cover.
Step 3. Release communication jacks and bezel Step 4. Rotate jack and push through flange as
from trim flange. Do not disconnect the shown below.
communication wires from jacks.
Repeat Steps 3 through 4 for the second jack.
RC3
Replacement Scrub Water
Cover Assembly Kit
INSTALLATION INSTRUCTIONS
Installation Instruction No.: 1 001 588 R1 – Updated December 2003
Walker ® electrical systems conform to and should be properly grounded
in compliance with requirements of the current National Electrical Code
or codes administered by local authorities.
All electrical products may present a possible shock or fire hazard if
improperly installed or used. Walker electrical products may bear the
mark as UL Listed and/or Classified and should be installed in
conformance with current local and/or the National Electrical Code.