Legrand Vista Series Archtectural Columns - Manual

Vista ™ Series
I N S TA L L AT I O N I N S T R U C T I O N S
Installation Instruction No.: 42140R1 – Updated February 2003
Wiremold Electrical Systems conform to and should be installed
and properly grounded in compliance with requirements of the
current National Electrical Code, Canadian Electrical Code or
codes administered by local authorities.
All electrical products may represent possible shock or fire
hazard if improperly installed or used. Wiremold electrical
products are cUL Listed, made for interior use only, and should
be installed in conformance with current local and/or the National
Electrical Code.
1
2a
2b
T-Bar Adapter
Threaded
Rod
Floor Trim
Level
Floor
Gripper Pad
Remove Ceiling tile from the grid if present.
For installation with a suspended ceiling. Use
the included T-bar adapter. Slide fitting over outside
channel and tighten as shown. Position T-bar clamp
over grid tee and tighten with thumbscrew.
For tying into ceilings
without suspended
grids. Use 3/8" [9.5mm]
threaded rod (not
included). Secure
to top plate using
provided knockouts
and appropriate
nuts. Attach to
ceiling structure.
Locate and attach
floor trim piece to
main support with the
four pan head screws
provided. Use
provided floor gripper
pads to secure to
floor. Use both pieces
for hard flooring. For
use with carpet use
only the coarse
portion of the pad.
Make certain
Vista Unit is
correctly oriented
and plumb before
securing to floor.
3a
For more permanent
mounting. Remove
provided knockouts
from steel base support.
Locate and attach floor
trim piece to main
support with the four
pan head screws
provided. Drive four
screws (not provided)
through trim piece and
into flooring. Minimum
recommended screws
size #8 x 1" [7.9mm
head size x 25mm].
Use proper hardware
for specific flooring
materials. Make certain
the Vista Unit is correctly
oriented and plumb
before securing
to floor.
3b
Floor Trim
Level