Legrand ALTP Tele-Power Pole - Manual

ALTP Tele-Power Pole
I N S TA L L AT I O N I N S T R U C T I O N S
Installation Instruction No.: 42521 – June 2003
Wiremold Electrical Systems conform to and should be
installed and properly grounded in compliance with
requirements of the current National Electrical Code, Canadian
Electrical Code or codes administered by local authorities.
All electrical products may represent possible shock or fire
hazard if improperly installed or used. Wiremold electrical
products are UL Listed to U.S. and Canadian safety
standards, made for interior use only, and should be installed
in conformance with current local and/or the National
Electrical Code.
The Wiremold Company
U.S. and International:
60 Woodlawn Street • West Hartford, CT 06110
1-800-621-0049 • FAX 860-232-2062 • Outside U.S.: 860-233-6251
Canada:
850 Gartshore Street • Fergus, Ontario N1M 2W8
1-800-741-7957 • FAX 519-843-5980
42521 – June 2003 – For latest specs visit www.wiremold.com
© Copyright 2003 The Wiremold Company All Rights Reserved
Step 1 Remove cover. Remove clamps
that hold in wireway. Withdraw
wireway from pole – do not
remove entrance end fitting.
Step 2 Determine length “A” to be
removed from pole. Fold wires
back and cut length “A” from
shown ends of cover, base,
and wireway.
Step 3 To re-assemble – Replace
wireway into the base with
conductors inside. Replace
and tighten down clamps.
Snap cover onto pole.
Cover
Wireway
Base
Clamp
Length
“A”
Clamp
Entrance
End Fitting
TO SHORTEN ALTP POWER POLE
BEFORE INSTALLATION:
Length
“A”
Length
“A”
NOTE: Tele-Power Pole must extend above hanger
clamp with Pole stanchion resting on floor.