Legrand ALDS4000 Designer Series Large Raceway User Manual
Page 2
2
Step 5. Use the #10-32 hole in the Coupling to
ground the system where it is fed.
Step 6. Make wiring connections between
raceway sections using connections
that comply with NEC and code
administered by local authorities.
INSTALLATION OF COMMUNICATIONS CABLING
Step 7. Wire Clip Installation – Additional Wire Clips are provided for the upper channel of the Raceway.
Step 8. Install Raceway Covers between Device Brackets
(Raceway Covers will overlap fittings bases). Raceway
Covers with pre-installed downward-facing flush
activations will snap on in the same manner.
Hook
Rotate clip and snap into place.
Wire Ties can be added if desired.
NOTE: Allow a 5 1/2" [140mm] maximum gap between
DS4000/ ALDS400 Series Raceway Covers.
5" [127mm] to 5 1/2" [140mm]
gap between Covers.
Hook Cover into Base Section.
Snap Cover into place to complete installation.