Legrand 4000 Series Large Steel Prewired Raceway Device Mounting Bracket - Manual

V4050/G4050, 5450
Device Mounting Bracket
Installation Instructions
Wiremold Electrical Systems conform to and should be installed
and properly grounded in compliance with requirements of the
current National Electrical Code, Canadian Electrical Code or
codes administered by local authorities.
All electrical products may represent possible shock or fire hazard
if improperly installed or used. Wiremold electrical products are UL
Listed. Made for interior use only and should be installed in con-
formance with current local and/or the National Electrical Code.
Refer to the Wiremold Limited Warranty and Liability Statement.
1 2
3 4
Disassembly
Desarme
Démontez
Holding Tabs*
Insertos de Montaje*
Les Insertions de Montage*
Wiremold 4000 or
6000 Series Raceway
NOTE: This bracket has been designed
and tested by The Wiremold
Company for use only with its
4000 or 6000 Series products.
Use with products or materials
not approved by The Wiremold
Company will void the product
warranty and could compromise
product performance and safety.
5" Min.
[127mm]
5" Min.
[127mm]
CM-EPLA
5
*Holding tabs must be covered with 5" [127mm] minimum of 4000 Series Cover.
*Los insertos de montaje deben de ser cubiertos y soportados por un minimo de 5 pulgadas [127mm] de Cubierta Series 4000.
*Il faut que les insertions de montage soient couvertes pour un minimum de 5 pouces [127mm] de la Couverture Series 4000.
V4050/G4050
u
For use with Wiremold 4000 & 6000 Series Raceway
CM-Activate
Modules
See reverse side for 5450