Legrand AU1004-XX - Manual

301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
Page 1 of 2
INSTRUCTION/INSTALLATION SHEET
FLUSHMOUNT SINGLE SOURCE
INPUT
IS-0392 REV. O
©Copyright 2007 by On-Q/Legrand All Rights Reserved .
1. Introduction
The On-Q /Legrand Flush Mount Single Source Input, PN AU1004-xx (see
Figure 1), is a wall mounted fixed version of the lyriQ™ Single Source Input
Unit. It is a component which, when combined with other essential components
and your source equipment receiver, CD player, etc, creates a versatile whole-
house audio system that will fill your rooms with high-quality sound for years to
come. The Category 5 technology utilized for whole house audio distribution
with the lyriQ™ system provides many advantages over other conventional
methods of audio distribution such as a low noise Category 5 wiring scheme,
and infrared control of system components. The Flush Mount Single Source
Input is available in white (-WH), light almond (-LA) and black (-BK).
2. Description
The Flush Mount Single Source Input typically resides at the entertainment center and is connected to the
enclosure mounted Audio Distribution Module using a single Category 5 cable run. This device receives line level
analog stereo audio output from the audio source equipment being distributed. If your receiver does not have a
dedicated line level or preamp output, use the tape monitor output. The Flush Mount Single Source Input provides
RCA jacks for audio source equipment connection and an adjustable gain control to balance inputs in a multi-
source application, or increase/decrease gain for a single input. The green LED indicates an active audio source.
IR signal distribution is supported by three (3) IR Emitter Output ports (IR on Tip, no connection to Ring and
Sleeve is grounded) and one (1) IR Target input port (+12V on Tip, IR on Ring and Sleeve is grounded). The IR
Target input is routed only to the three Emitter outputs. A red LED is provided to indicate IR activity.
3. Installation
IMPORTANT: Read all technical information that is included with all associated lyriQ™ Audio products
before installation of any single component! If you are unsure of any of the following installation
procedures contact On-Q/Legrand Technical Support @ 1-800-321-2343 option 1 or contact an On-
Q/Legrand installer.
NOTE: The Flush Mount Single Source Input, like other On-Q/Legrand lyriQ™ Audio system components,
is powered by the On-Q/Legrand lyriQ™ Audio Distribution Module.
NOTE: To provide ultimate flexibility for future products, run two Category 5 cables from the Flush
Mount Single Source Input to the lyriQ™ Single Source 4 Zone Distribution Module. Also, run a 16/4
speaker cable, along with the Category 5 cable, from the Single Source 4 Zone Distribution Module to
each volume control location.
A. Run a Category 5 cable from a low voltage bracket at the room location containing the Flush Mount Single
Source Input (typically the entertainment center location) to the lyriQ™ 5 Audio Distribution Module located
in the Enclosure.
B. Make sure that the Power Supply is not connected to the Audio Distribution Module at this time.
Figure 1