Legrand MS3523-BK - Manual

INSTRUCTION / INSTALLATION SHEET
evōQ™ 3000 5.25” Outdoor Speakers
IS-0257 Rev. C
301 Fulling Mill Road, Suite G
Middletown, PA 17057
Phone (800) 321-2343 / Fax (717) 702-2546
www.onqlegrand.com
©Copyright 2007 by On-Q/Legrand All Rights Reserved. Page 1 of 2
1. INTRODUCTION
On-Q/Legrand offers 5.25” evōQ™ 3000 Outdoor Speakers for
external wall mounting on provided brackets. These speakers
(P/N MS3523-WH for white and P/N MS3523-BK for black) see
Figure 1
), are sold in pairs and are optimized for outdoor audio
distribution (central sound). They feature 5.25” Poly woofers and
PEI (Polyetherimide) Mylar tweeters. The provided brackets
allow the speakers to be adjusted for sound direction.
Disclaimer: Make sure you are in compliance with local
building codes before installing these speakers. These OnQ
evōQ™ 3000 Speakers are designed for outdoor
applications and are also suitable for other moisture rich
environments such as bathrooms or saunas.
2. DESCRIPTION
The On-Q evōQ™ 3000 Outdoor Speaker is made of a tough semi-flexible plastic and also features a
perforated aluminum grill. The brackets are powder coated aluminum with brass fasteners and stainless
steel screws..
3. INSTALLATION
NOTE: It is recommended that a minimum of 16 gauge, 2 conductor wire be used
for most applications from the amplifier or volume control to the speaker. Different
gauges can, and should, be used based upon the distance of the intended run or
quality of installation (see Figure 2)
NOTE: The On-Q/Legrand lyriQ™ Audio components all accommodate wire
gauges from 18 to 14.
A. For pre-wire, run x/2 conductor (x=gauge) stranded speaker wire from the distribution/volume
control to each outdoor speaker location.
B.
Drill a hole large enough to accommodate the speaker wire
through the outside wall at an appropriate location for each
outdoor speaker, and place each speaker wire from the
volume control through the hole to the outside. Leave at
least a foot of wire outside, and seal the hole with caulk.
C.
Place the speaker wire through the hole in the center of the
evōQ™ 3000 Outdoor Speaker bracket, and mount the
Outdoor Speaker brackets to the outside wall using two
screws per bracket (see Figure 3), and the appropriate
retention device (i.e. masonry inserts for a masonry wall).
Figure 1
Distance Gauge
<10 Feet 18
10-50 Feet 16
>50 Feet 14
Figure 3
Figure 2