Legrand RW3U600 - Manual

In
sta
lla
tio
n I
ns
tr
uc
tio
ns
Please read all instructions before installing
DESCRIPTION AND OPERATION
The RW3U600 Multi-way Wall Switch Occupancy Sensors are designed to replace
standard multi-way (3-way, 4-way) switches. They are ideal for any room with
multiple entries such as living and dining rooms, family rooms, bedrooms,
bathrooms, hallways, and any other indoor space where occupancy sensor-based
controls are desirable.
The RW3U600 has 2 modes of operation - vacancy or occupancy sensor. While the
sensor is factory preset as a Vacancy Sensor with manual ON operation, it can
be adjusted to work as an occupancy sensor that turns the controlled load ON
automatically upon detection of occupancy in the area.
In vacancy sensor mode, you can press the ON/OFF button to turn the light or fan
(controlled load) ON and OFF like a standard switch. In occupancy sensor mode, the
lights will turn on automatically when the space becomes occupied. The RW3U600
automatically turns OFF the controlled load after the coverage area has been vacant
for a period of time (Time Delay). If motion is detected within 30 seconds after it
automatically turns OFF, the RW3U600 automatically turns the load back ON.
Lighted Switch
To help you locate the RW3U600 in a dark room, the green LED illuminates the
ON/OFF button while the controlled load is OFF. When the controlled load is ON,
the LED is OFF.
Operating Modes
For multi-way operation, the Operating Mode must be the same in all sensors
related to the same load. There are two operating modes to select from:
MODE 1 Vacancy sensor (Manual-ON/OFF, Auto-OFF): The user must press the
ON/OFF button to turn the load ON. The RW3U600 keeps the load ON until no
motion is detected by any of the related RW3U600s for the time delay period. There
is also a 30 second reset delay after the automatic shut-off. If motion is detected
during this time, the sensor turns the load back on automatically. After the
30 second reset delay has elapsed, the ON/OFF button must be pressed to turn
ON the load.
MODE 2 Occupancy sensor (Auto-ON/OFF with manual control and reset to auto
after 5 minutes of vacancy): The load turns ON and OFF automatically based on
occupancy detection. Once turned ON the RW3U600 keeps the load ON until no
motion is detected by any of the related RW3U600s for the time delay period. If
the load is turned OFF manually, automatic-ON is re-enabled when no motion is
detected for 5 minutes. This prevents the load from being turned on after it was
deliberately turned OFF.
SPECIFICATIONS
Voltage ...............................................................120VAC, 60Hz
Load (Single Pole Circuit)
Incandescent or fluorescent ............................ 0-600 Watts
Fan motor .................................................................. 1/6 hp
Time Delay Adjustment ..........15 sec., 5 min., 15 min., 30 min.
Light Level Adjustment .......................................10 fc to 150 fc
Environment ..................................Residential Indoor use only
Operating Temperature ............... 32° to 131°F (0° to 55°C)
Humidity ...................................... 95% RH, non-condensing
Tools Needed
Insulated Screwdriver
Wire Strippers
Call 800.223.4185 for Technical Support
RW3U600
Multi-way
Wall Switch
Occupancy Sensor
with Manual ON/OFF
Lens
Lighted Switch
ON/OFF Button