Legrand IC5400 - Manual (Page 11)

Page 7
301 Fulling Mill Road, Suite G ©Copyright 2008 by On-Q/Legrand,
Middletown, PA 17057 Inc All Rights Reserved.
(800)-321-2343 www.onqlegrand.com
Selective Call Intercom Distribution Module/s
The rough-in of the On-Q Enclosure that will house the Intercom Distribution Module/s will need
to be completed per the enclosure’s installation instructions. There is no further rough-in work
required for the Intercom Distribution Module since this component will mount directly in the On-Q
Enclosure during trim-out.
B. Final Wiring (Trim-Out)
The trim-out of the system should be completed after wall coverings have been finalized. The
following section will instruct you on the proper methods to finish the installation of the various
Selective Call Intercom System components.
Selective Call Room Unit(s)
The procedure to trim-out the Room Unit(s) is as follows:
• Locate a Cat 5e cable in a roughed in 2 gang box labeled as “Room Unit X” (X is the Room
Unit number).
• Strip approximately 2” of insulation from the Cat 5e cable.
• Untwist cable pairs and place them next to each other in color-coded order according to
theT568A standard and insert the wires into an RJ45 plug.
• Crimp the RJ45 plug onto the cable with a proper RJ45 crimp tool.
• Plug the terminated “Room Unit X” cable into the RJ45 jack on the rear of the Room Unit (see
Figure 5).
• Insert the Room Unit and the Cat 5e cable into the 2 gang box and secure the unit to the box
using the 4 included pan head screws. Screw the wall plate frame to the Room Unit using the
4 provided flat head screws and snap on the supplied Room Unit decorator style wall plate
cover to complete the installation.
• Repeat these instructions for all the Room Units in your Selective Call Intercom System.
Figure 5
RJ45
jack
Mounting Box
Screw location
(4 places –
pan head style) Wall Plate
Mounting Plate
Screw location
(4 places –
flat head style)