Legrand 363292-01 - Manual

Legrand Products:
363292-01 - Cat 5 Strip and Fit Tool
AC3400 - Punch & Go Tool
WP3475-WH - Cat 5 Quick Connect RJ45
Keystone Connector
Using the Punch & Go Tool
1.
iTems Needed
www.legrand.us/onq
3.
How To sTeP-by-sTeP
Step 1
Use the Strip and Fit tool to cut off
approximately two inches of the
jacket.
Step 2
Cut the wire separator strands, separate
the pairs and untwist them.
Step 3
Now fan them out in the T568A pattern.
White/Green
Green
White/Orange
Blue
White/Blue
Orange
White/Brown
Brown
TOOLS & AddiTiONAL SUPPLieS:
• Wire Cutter
• Continuity Tester
• Cat 5 Cable
• RJ45 Jumper Cable
2.
iNTRodUCTioN
A structured wiring foundation is
the most effective way to distribute
information throughout a home. it
supports high-performance technology
through clutter-free cabling hidden
behind the walls. To ensure more
efficient installation, run a single home
run to a central distribution point and
bundle cables for access to multiple
services. There are several fundamentals to
remember when working with Cat 5:
• On-Q products utilize the T568A wiring
standard
• Never splice Cat 5 cable
• Always maintain a 12-inch minimum
separation between the Cat 5 and any
120 Volt AC cabling. if you must cross
and electrical circuit, do so at a 90
degree angle
• Always maintain a minimum bend
radius of 1 inch.
• Never exceed the 25 pound pull limit.
doing so may pull the twists out of
the wire, which is what gives Cat 5 its
immunity from interference. For the
same reason, you shouldn’t stand on
the wire or use any retention devices
that flatten out the wire.