Dialogic DSI SS7MD - Manual (Page 156)

156
7 Configuration Command Reference
7.9.3 TCAP_TRACE – TCAP Trace
Synopsis
The TCAP_TRACE command is used to configure TCAP to send trace messages to the trace module whenever
a specific message type is sent or received. See the TCAP Programmer’s Manual for details.
Syntax
TCAP_TRACE <op_evt_mask> <ip_evt_mask> <non_prim_mask>
Example
TCAP_TRACE 0x7 0xf 0x0
Parameters
The TCAP_TRACE command includes the following parameters:
•
<op_evt_mask>
Output event trace mask.
•
<ip_evt_mask>
Input event trace mask.
•
<non_prim_mask>
Non-primitive trace mask.