Leprecon VX Series Non-Dim Programming Instructions - Manual

Revised VX Software :
Allows any of the channels on the pack to be set for non-dim operation. The information, once set, is
stored in the pack memory and is retained permanently. Using a specific DMX switch setting sets the
channel operation. Once the switch is set, press the ‘enter’ switch on the front panel, or cycle power
to the dimmer.
There are two ways to make a channel a non-dim channel:
1) Set a single channel by setting the DMX code shown below, and press ‘enter’.
DMX Function
801 Channel 1 Non-dim
802 Channel 2 Non-dim
803 Channel 3 Non-dim
804 Channel 4 Non-dim
805 Channel 5 Non-dim
806 Channel 6 Non-dim
807 Channel 7 Non-dim
808 Channel 8 Non-dim
809 Channel 9 Non-dim
810 Channel 10 Non-dim
811 Channel 11 Non-dim
812 Channel 12 Non-dim
Setting 899 and pressing ‘enter’ clears all non-dim channels.
2) Set several channels at once. Connect a functioning console to the VX dimmer. Apply power. Set
the address to 800. Channels with levels above 10% will be programmed as non-dim. The settings
are memorized when ‘enter is pressed.
Setting 899 and pressing ‘enter’ clears all non-dim channels.