LSC Lighting TEKO - Manual (Page 20)

TEKO Dimmer
Operator Manual V3.0
To record a memory press:
[Record Memory].
The current output of the TEKO (if any) is
blacked out.
The memories are organised in 4 banks of 20
memories. The buttons on the right select the
banks. Select the bank and memory number to
be recorded. When a memory is selected its
contents are shown on the output of the TEKO
and also on the channel indicators. This allows
you to preview the contents of memories on the
output and either pick an empty or existing
memory.
To confirm your selection press [Pick].
If the memory exists, it will be deleted. To
confirm press [Yes].
To vary the level of a channel it must be
selected. The selected channel is shown below
the memory number and also indicated by small
triangle () above the selected channel(s). In
this example channel 5 is selected.
There are two methods to select channels:
 Press [] or [] to step () through the
channels.
 Press [Pick Chans] to reveal the
channel pick screen.
 To select a channel, press that channel
number. Selected channels have white
text on a black background.
 You can add further channels to your
selection by pressing their channel
numbers.
 To deselect a channel, press it again.
 To select a range of channels, press a
channel, then [Thru] then another
channel.
 To invert your selection(s) press [Inv]
 To select all channels with a level
greater than zero press [Lvl > 0].
 To select all included channels
(including those with level of zero) press
[Lvl > = 0]. See “How Memories Work”
for details on included channels with a
level of zero.
 To clear all selections, press [Clr].
When the required selections have been made
press [Pick] and the screen returns to the
“Modify Memory” screen.
To set the level of the selected channel(s) either:
▼ indicates selected
channel(s)  Slide the virtual fader
 Press the [0%] or [100%] buttons.
 Press [@ Level] and enter a value.
Channel levels can also be set using the DMX
input from a lighting controller. Press [Snap
DMX] to take a snapshot of the DMX input
signal.
Virtual fader
If you do not want to capture the level of all
channels you can use the “selected” option to
only include the levels of the channels that you
have selected. See “Included Channels” below.
5.5.2 Included Channels
If a channel is not included in a memory then
the channel is not affected when that memory
is faded up or down.
LSC Lighting Systems (Aust) Pty. Ltd Page 18