LSC Lighting iPatch - Manual (Page 4)

LSC Lighting Systems (Aust) Pty Ltd Page 3
iPATCH Installation guide
2.0 Installation
This installation procedure is intended as a guide for the installer, as variations will occur
depending on the installation location. All wiring must be performed by a licensed electrician.
1. Remove the four screws holding the front cover of the iPATCH to the rear chassis and
remove the cover.
2. Determine where the load circuit wiring will enter/exit the rear chassis and remove the
required cable knockouts.
3. Install the rear chassis onto the desired flat surface using the mounting holes provided.
4. Terminate the load wiring into the supplied screw terminal strips starting with circuit
number one (1). Ensure the Active and Neutral load wires are correctly terminated into
the label side of the terminal strip. See Figure 1 below. The earth wires are terminated
into the Line taps located above the terminal strips.
5. Connect power (Active, Neutral, Earth) to the test circuit power connector.
6. Replace the front cover (ensuring that the test circuit plug is connected into the test
circuit power connector socket on the rear chassis) and secure with the four screws
removed in step1.
Figure 1
iPATCH wiring detail
Screw terminal strips
Earth terminals