LSC Lighting monoPAK - Manual (Page 3)

LSC Lighting Systems (Aust) Pty Ltd. Page 2
monoPAK Single channel portable dimmer monoPAK Single channel portable dimmer monoPAK Single channel portable dimmer monoPAK Single channel portable dimmer
Using the monoPAK Using the monoPAK Using the monoPAK Using the monoPAK
Before using the monoPAK on your selected load, it is important to confirm that the power
required by the load does not exceed the output power rating of the monoPAK dimmer
(2400Watts@240Volts AC), otherwise the dimmer could be damaged.
The monoPAK is a versatile single channel 10Amp dimmer suitable for followspots, stage
props, photography studios, film locations, retail outlets, trade exhibititons etc… The integral
cables allow the monoPAK to be installed in series between an AC power source and a
dimmable load. Adjusting the sliding fader varies power to the load.
The load should NOT be connected or removed while the monoPAK is supplying power to the
load. Always adjust the sliding fader to the minimum position (0 power level) before adding
or removing a load.
Technical Specifications Technical Specifications Technical Specifications Technical Specifications
Maximum output load 2400Watts @ 240V input.
Input Voltage Range 200 – 250VAC @ 50/60Hz.
Input Protection 10 Amp HRC M205 Fuse.
Inductor Rise Time 250-300usec (peak to peak).
RF suppression Input and output filters to CE requirements.
CE and C Tick Approved Yes.
Dimensions (excluding cables) 255mmL x 94mmW x 73mmD
Weight 4.0kg (5.0kg packed).
Construction Zinc steel finished in textured black powdercoat.,
Rear silk screened polycarbonate front panel.
Mounting Specifications Mounting Specifications Mounting Specifications Mounting Specifications (mm)
256.0
234.0 15.0
94.0
47.0