Windows 98/me® installation, Running setup, Installing the lynx l22 – Lynx Studio L22 User Manual
Page 6: Restarting your computer
Page 6
Windows 98/ME® Installation
The procedure for installing the Lynx L22 in Windows 98/ME requires that the Lynx
L22 Setup Program be run before you install your Lynx L22 inside your computer.
This program will install the required driver files needed for the Windows Plug-and-
Play configuration manager to recognize the Lynx L22 as a new device and will install
the Lynx L22 Mixer application.
Running Setup
1.
With your computer running Windows 98/ME, insert the 3½” floppy supplied
with your Lynx L22 into your computer’s floppy disk drive.
2.
Select “Start” from your system menu, then “Run…”.
3.
Type A:\SETUP.EXE into the Run window and select the OK button.
4.
The “LynxTWO/Lynx L22 Windows 98 Driver Installation Wizard” will appear.
5.
After reading the instructions on the screen, press “Continue”.
6.
The Driver Installation Wizard will copy all of the files needed to the appropriate
directories.
7.
When the “Installation Complete” message appears, read the instructions on the
screen, then press “Shutdown”.
Installing the Lynx L22
1.
Turn OFF the power to your computer system and disconnect the power cords.
2.
Touch a metal plate on your computer system to ground yourself and discharge
any static electricity.
3.
Remove the cover from your computer system case. You should refer to your
computer system documentation for any special instructions on installing expansion
cards and peripheral equipment.
4.
Find an empty PCI slot in your computer.
5.
Unscrew and remove the slot cover from your selected PCI slot.
6.
Remove your Lynx L22 from its static bag and gently insert it into the selected
PCI slot. Press it down firmly so that the contacts are securely seated in the slot.
7.
Secure the Lynx L22 card with the screw removed from the slot cover.
8.
Replace the computer system case and plug in your computer.
9.
Connect the L2Audio and L2Sync cables to the Lynx L22. See the External
Connections section for more information.
Restarting Your Computer
1.
Turn on your computer and start Windows.
2.
After the Windows logo splash screen is complete, the Plug-and-Play configuration
manager will display a “Found New Hardware” message.
3.
Windows will ask where the driver is located. You should enter:
C:\Windows\System
Then click on “OK”.
4.
Depending on your hardware setup, Windows may need to restart before
proceeding.
5.
Please read the “Release Notes” in the startup menu “Lynx Studio Technology”
group.
Installation