Lynx Studio Hilo Reference A/D D/A Converter System - LynxRedirector User Guide - Manual (Page 2)

Initial Setup
First, make sure your Hilo is connected directly to the Host Computer and the driver is loaded (if required).
Next, make sure the Host Computer is connected to your network and has been assigned an IP address.
Launch LynxRedirector on your Host computer. If your Hilo is connected via USB, you will see a screen similar to this:
If your Hilo is connected via Thunderbolt, you will see a screen similar to this:
You need only make a change to LynxRedirector if you have multiple Hilo’s connected to the Host Computer.
Next, make sure your Target Computer/Tablet is connected to the same network as the Host Computer and has been
assigned an IP address.
Finally, launch Hilo Remote on the Target Computer/Tablet. You should see the Wi‐Fi connected icon on the right side
of the toolbar: