Marantz SR5009 - Manual (Page 222)

Symptom Cause / Solution Page
Dolby PLg mode or DTS
Neo:6 mode cannot be
selected.
0
It cannot be selected when “Speaker Config.” - “Center” or “Surround” is set for “None”. 189
0
Dolby PLg or DTS Neo:6 cannot be selected when using headphones. －
Audyssey MultEQ ® XT,
Audyssey Dynamic EQ ®
and Audyssey Dynamic
Volume
® cannot be
selected.
0 These cannot be selected when you have not performed Audyssey ® Setup. 178
0
Switch to a sound mode other than “Direct” or “Pure Direct”. 120
0
These cannot be selected when using the headphones. －
“M-DAX” cannot be
selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
multichannel signals such as Dolby Digital or DTS surround, “M-DAX” cannot be used.
156
0
Switch to a sound mode other than “Direct” or “Pure Direct”. 120
No sound is output when
using ZONE2.
0
Digital signal audio input from the HDMI connector or digital audio connectors (OPTICAL/COAXIAL)
cannot be played back. Use analog connections.
－
0
When listening to the audio of a Bluetooth device in ZONE2, remove any obstructions between the
Bluetooth device and this unit and use it within a range of about 32.8 ft/10 m.
－
Contents Connections Playback Settings Tips Appendix
222 Front panel Display Rear panel Remote Index