Datalogic Scanning Industrial PDA - Manual (Page 8)

Powering the Pegaso
6 Pegaso™ Industrial PDA with Windows
®
CE
CAUTION
You must charge the battery pack and backup battery in a dock or
with a power cable prior to your first use of the Pegaso. The initial
charge time is approximately 4 hours.
If you remove the battery pack or it fails, there is a 30-minute window
in which to insert a charged battery pack before the backup battery
fails. If your backup battery fails, the contents of the RAM memory
will be lost. If your backup battery is less than fully charged, there is a
smaller window of time available. Usage time will be reduced, also.
Always charge within temperature range of 32°–113°F (0°–40°C). Reg-
ularly charging near the temperature limits will increase the time nec-
essary to fully charge the battery, and will shorten the battery’s useful
life.
Use only the authorized power supplies, battery packs, chargers, and
docks supplied by your Datalogic reseller. Use only the battery pack
that is specified. Only use the battery with a charging system that has
been qualified with the system per this standard. Use of an unquali-
fied battery or charger may present a risk of fire, explosion, leakage,
or other hazard. Unauthorized battery pack and improper use of either
battery pack or charging system may present a risk of fire, explosion,
leakage or other hazards. The use of other power supplies can dam-
age the unit and void your warranty. Refer to the PRG for the correct
power supplies and Accessories.