Dolby Laboratories KH 02 - Manual (Page 96)

96
4 Possible cause:
The loudspeaker cables have been short-circuited through incorrect connection.
4 Solution:
Switch the device OFF and connect the loudspeaker cables correctly.
4 Problem:
There is no video signal to be seen on the television when the input selection switch is swit-
ched to DVD 5.1 or VCR.
4 Possible cause:
Video outputs for the DVD player and VCR unit have been connected up the wrong way round.
4 Solution:
Switch the device OFF and connect the video inputs correctly.
Subwoofer
4 Problem:
No bass can be heard from the subwoofer.
4 Possible cause:
1. The automatic mains OFF switch is turned to OFF;
2. The subwoofer with mains connection is not connected to the amplier.
4 Solution:
1. Switch it ON;
2. Connect the subwoofer to the subwoofer output of the amplier using the RCA cable included.
Remote control
4 Problem:
The remote control is not working.
4 Possible cause:
1. The batteries are at;
2. The remote control is too far away from the amplier.
4 Solution:
1. Replace the batteries by new ones;
2. Move closer to the amplier with the remote control to make sure you are within the
receiver range of the infrared receiver.
Note: DVDs can contain passages with extremely loud volume signal levels which cause distortion
if they are replayed at maximum volume. Reduce the volume if such distortion occurs. If you ope-
rate the loudspeakers over a longer period of time with such distortion, this can lead to damage
to the loudspeakers and/or the amplier.
H
EADPHONE OPERATION
Insert the headphone plug (6.3 mm jack connecter) into the headphone jack on the front panel
of the amplier. The loudspeakers are then switched off automatically.
C
LEANING THE DEVICE
Use a slightly damp soft cloth and a mild cleaning detergent. Use no chemicals, alcohol, thinning
agents or other solvent-containing cleaners.
O
PERATING
M
ANUAL