Operating instructions – DeLonghi 3300 User Manual
Page 17
17
OPERATING INSTRUCTIONS
• after around 30 minutes, when the light comes on (section 12 -
point 1), turn the steam knob half a turn clockwise (Fig.6) until it
stops.
The machine must be rinsed so as to eliminate the residues of descaling
solution from inside the machine. Proceed as follows:
• remove the water tank, rinse it and fill it with clean water.
• reposition the tank.
• empty the collection container (located under the milk frother) that is
full of liquid, and then replace it under the milk frother.
• turn the steam knob half a turn counter-clockwise (Fig. 5). Hot water
will come out of the milk frother and fill the container underneath.
• when the tank is empty, the l ight goes off and the light
comes on (section 12 - point 1).
• turn the steam knob all the way clockwise (Fig. 6) and fill the water
tank with clean water again.
• the program of descaling is now terminated and the machine is
ready to make coffee again.
NOTE: if the descaling procedure is interrupted before completion,
the
alarm (section 12 - point 5) is not deactivated and the pro-
cedure must be started again form the beginning.
IMPORTANT: FAILURE TO DESCALE THE APPLIANCE REGULARLY INVALIDATES
THE WARRANTY.
10.4 SETTING THE WATER HARDNESS
The light (section 12 - point 5) switches on after after the machine has
been operated for a factory set period of time calculated on the basis of the
maximum quantity of lime scale which may be contained in the water used. If
necessary, this period of operation can be extended, thus making the descal-
ing operation less frequent, by programming the machine based on the actual
lime content in the water used. Proceed as follows:
• after having removed the "Total hardness test" strip (enclosed on page 2)
from its packaging, dip it fully in the water for a few seconds, then pull it
out and wait around 30 seconds (until it changes color anda number of
squares are formed);
• check that the machine is off (all the indicator lights are off);
• press the button (Fig. 14) and hold it for at least 5 seconds. The four
lights , , and come on.
• press the button (Fig.18) repeatedly until the number of lights that are
on coincides with the number of red squares on the test strip (for example,
if there are 3 red squares on the test strip, press the button until 3 indi-
cator lights come on together, , and ).
• press the button (Fig. 14) to save the data. The coffee maker is now
programmed to provide the descaling warning when effectively necessary,
based on the actual hardness of the water.