Configuring your remote, Press, On the remote again – Directed Electronics 1401 User Manual
Page 22: Button followed by the
14
© 2011 Directed Electronics. All rights reserved.
Press
A U
X
on the remote again.
➢
Configuring your remote
The remote control has a menu for programming user features. Before you start
make sure the keypad is unlocked. (See Button Auto Lock )
To configure the remote user features:
1. Press and hold the
A U
X
button on the remote for 8 seconds. The remote
transmit LED turns on solid to indicate the Main Menu.
2. Press and hold the
A U
X
button for 1.5 seconds: The remote LED blinks
two-times. You are now in the Remote Configuration menu. From this
menu you can now configure the remote's keypad lock features, as
described in the following steps.
Note: To exit Remote Configuration menu:
Press and release the
A U
X
button to go back and repeat to exit. The transmit LED
turns off when programming is exited.
Button Auto Lock
When On, the remote Control buttons lock if more than 20 seconds lapses
between button presses. If a button is pressed when locked, the transmit LED
does not light up to indicate that the buttons have been locked. To unlock
the buttons; press the
A U
X
button followed by the
A U
X
button. The transmit LED
flashes three times to confirm.
Button Auto Unlocking
After turning the ignition off, the remote unlocks the buttons until the next com-
mand is performed. If you do not want Auto Unlocking, it can be turned off by
an authorized Directed Dealer.
Car Select
Car 2 must first be turned On (See Remote Features menu in the following Pro-
gramming section to turn on). Press and hold the
A U
X
button for 3 seconds. The
remote flashes the LED once or twice to indicate the selected Car is 1 or 2,
release the button for Car Select or continue holding for programming. Release