Dimension One Spas Chairman II - Manual (Page 2)

Specification, 2005, Chairman II Doc-1211 Rev - B Rev Date: 1/31/05
2005 Chairman II Specifications Dimension One Spas
2005 Chairman II
Note: 1. Subject to change without notice.
Top View of Spa
THE EDGES OF SPA BASE.
SUPPORTED CONSISTENT WITH
ON BOTTOM OF SPA, TO BE
THIS 3 FOOT SQUARE AREA,
91 1/2 in [232 cm]
Shell
See Caution
91 in [231 cm]
Skirt
89 in [225 cm]
Pedestal
Base
16 in [41 cm]
16 in [41 cm]
23 1/2 in [60 cm]
34 1/2 in [88 cm]
56 1/2 in [143 cm]
67 1/2 in [171 cm]
27 in [67 cm]
Recommended location
for
Electrical
11 in [28 cm]
Hose Bib/
Water Drain
32 in [81 cm]
3 1/2 in [9
16 in [41 cm]
75 in [191 cm]
Pedestal Base
Front View of Spa
35 1/2 in [90 cm]
91 in [231 cm]
Hose
Bib/
Door Extends
Under Spa Lip
Vent
Vent
See Note 5
91 1/2 in [232 cm]
89 in [225 cm]
Control
Spa Lip
Sequencer
Control
Sequencer
valve
Equipment
Compartment
17 in [44 cm]
19 in [47 cm]
12 in [30 cm]
SIS
R16 in [R41 cm]Shell
R16 in [R40 cm]
2. Engineering specs may differ slightly from brochure.
3. For E-Z lifter installation allow 18” clearances on the backside of the spa.
4. Alternative cabinets may add significant weight. Ask your dealer for exact details
5. This is the approximate location for drilling a hole if you must bring the power line in through the bottom of the spa.
Be careful not to puncture a plumbing line inside the equipment compartment(drill from the inside compartment out).
Page 2 of
2
Architectural Specification
Vent
Caution:
Due to manufacturing tolerances there could be some
minor differences between the actual spa and the drawing above.
If site planning is critical to such tolerances, be sure to measure your actual spa.