Disc handling and maintenance, Handling precautions, A) (b) – Dolby Laboratories DVD Player User Manual

Page 28: If the surface is soiled (c), Improper disc storage, Disc which cannot be played with this player, Maintenance, For y our reference, Be careful not to drop or bend the disc, Do not install more than 1 disc on the disc tray

Advertising
background image

For Y

our

Reference

2 5

Disc Handling and Maintenance

Handling Precautions

!

Hold the disc by the edges so the surface will not be soiled
with fingerprints. (A)
Fingerprints, dirt and scratches can cause skipping and
distortion.

!

Do not write on the label side with a ball-point pen or other
writing utensils.

!

Do not use record cleaning sprays, benzine, thinner, static
electricity prevention liquids or any other solvent.

!

Be careful not to drop or bend the disc.

!

Do not install more than 1 disc on the disc tray.

!

Do not try to close the disc tray when the disc is not installed
properly. (B)

!

Be sure to store the disc in its exclusive case when not in use.

If the surface is soiled (C)

Wipe gently with a soft, damp (water only) cloth.
When wiping discs, always move the cloth from the center hole
toward the outer edge.
(If you wipe the discs using a circular motion, circular scratches
are likely to occur, which will cause noise.)

If the disc is brought from a cold to a
warm environment, moisture may form on
the disc

Wipe this moisture off with a soft, dry, lint-free cloth before using
the disc.

Improper disc storage

You can damage discs if you store them in the following places:

!

Areas exposed to direct sunlight

!

Humid or dusty areas

!

Areas directly exposed to a heat outlet or heating appliance

Disc which cannot be played with this player

!

CD-ROM

!

CDV

!

CD-G

!

DVD with a Locale No. other than that shown on the DVD
unit’s Region Code Label on the rear panel

!

Do not try to play Photo CD

Maintenance

!

Be sure to turn the unit off and disconnect the AC power cord
before maintenancing the unit.

!

Wipe this unit with a dry soft cloth.
If the surfaces are extremely dirty, wipe clean with a cloth
which has been dipped in a weak soap-and-water solution and
wrung out thoroughly, and then wipe again with a dry cloth.

!

Never use alcohol, benzine, thinner, cleaning fluid or other
chemicals. And do not use compressed air to remove dust.

(A)

(B)

(C)

Advertising