Measurement Computing DBK41 - Manual

DBK41
10-Slot Expansion Module
Overview …… 1
Hardware Setup …… 2
Card Configuration …… 2
Power Configuration …… 2
Card Insertion …… 3
EMI Shield Plates for CE Compliance …… 4
System Connection …… 5
DBK41 – Specifications …… 5
Reference Notes:
o Chapter 2 includes pinouts for P1, P2, P3, and P4. Refer to pinouts applicable to your
system, as needed.
o In regard to calculating system power requirements, refer to DBK Basics located near
the front of this manual.
Overview
The DBK41 is a metal enclosure that holds up to 10 DBK cards. The exterior front panel has a male DB37
connector that leads to the LogBook or Daq device or further expansion via a CA-37-x cable. On the
inside of the front panel, a backplane printed circuit board (PCB) uses 10 female DB37s with their pins
connected in parallel to distribute the P1 interface (can also be used with P2 or P3). From the rear panel,
the DBKs’ signal input lines exit to their respective transducers.
An optional EMI kit provides shield plates for the rear panel to make the DBK41 CE-compliant and
prevent EMI from DBKs entering the test environment (or vice-versa). The EMI kit also functions as an
electrical safety barrier.
Some DBK cards require a lot of power, in relation to other cards, and the use of power is an important
concern. DBK cards can obtain power externally from a LogBook, DaqBook, DaqBoard; or internally
from a DBK32A or DBK33 card. Refer to Power Requirements in the DBK Basics section, as well as the
sections for the DBK32A and/or DBK33, as applicable.
A power card in any slot (other than the slot leftmost from rear view) will power the
other cards via the backplane. A front panel LED will light whenever power from any
source is on the backplane. DBK41’s JP1 jumper can be positioned to disable the +5 V
power line from the external DB37. This prevents a DBK33 power supply from
interfering with other devices.
DBK Option Cards and Modules 877095 DBK41, pg. 1