Measurement Computing DBK48 - Manual (Page 7)

8B Isolated Signal Conditioning Module 967792 DKB48, pg. 7
Setting DBK48 Module Addresses
Up to sixteen DBK48 modules can be attached to a single LogBook or Daq device. Each DBK48 module
must have a unique channel address because they connect to the primary data acquisition device via
parallel interface.
CAUTION
Adjustment of the channel address must only be performed when the system
power is OFF. Failure to do so may result in equipment damage.
To assign a channel address to the DBK48 module, first locate the DIP switch on the right side of the rear
panel. Four micro-switches [on the DIP switch] are used to set the module’s channel address in binary.
After ensuring that the system power is OFF, adjust the micro-switches to set the desired address. The 16
possible addresses are illustrated in the following figure.
Each module in the system must have a unique primary device channel address.
The 16 Possible Address Settings for DBK48 Modules