Measurement Computing ChartScan Rack Mount - Manual

483-0902, Rev. 1.0 Released Per EO# 2055R14, May 1998 ChartScan Rack Mount, Installation Guide 1
ChartScan Rack Mount, Installation Instructions
Rack Mount Kit CSN/Rack1
About this Instruction Sheet
This instruction sheet contains illustrations and instructions for two types of Rack Mount Kit, the
CSN/Rack1 and the CSN/Rack2. The CSN/Rack1 kit is used to rack mount a single ChartScan unit.
CSN/Rack2 is used to rack mount a ChartScan/Expansion Chassis assembly. The instructions for
CSN/Rack2 appear on page 2.
Inspecting your CSN/Rack1 Kit
Check all CSN/Rack1 contents for damage which may have occurred during shipment. Immediately
report any damage to the shipping agent and your sales representative. Retain all shipping materials in
case the kit must be returned to the factory.
Mounting ChartScan to a Rack using Kit CSN/Rack1
Note: CSN/Rack1 components, quantities and assembly orientations are represented in the figure
below. Please refer to the figure before assembly and again during assembly, as needed.
1. Ensure the ChartScan unit is not connected to any power source or device.
2. Orient the ChartScan/1400 such that the desired panel (front or rear) will face the mount kit Face Plate
(483-2023) during assembly.
3. Loosely mount the Left and Right Side Plates (483-2024 & 483-2025) to the sides of the ChartScan unit
using two Screws (HA-152) for each side plate. Do Not fully tighten these screws at this time.
4. Mount Face Plate (483-2023) to the two Side Plates using four Screws (HA-7) and two Handles (HA-153)
as indicated in the figure. The Screws go through the Side Plates, through the Face Plate, and thread into
the Handles.
5. Ensure proper mating of ChartScan and rack mount parts, then tighten all screws snug.
6. Mount the assembled unit to your instrument rack using the four remaining Screws (HA-7).
This completes the installation using rack mount kit CSN/Rack1.