Duracraft DH-890 - Manual (Page 5)

NOTE: We recommend that the humidifier be disinfected prior to first use.
Please see CLEANING instructions.
• Select a firm, level, flat location — at least six inches (15 cm) from any wall for proper air
flow (Fig. 1).
• Place the humidifier on a water-resistant surface, as water can damage furniture and some
flooring. Duracraft ® will not accept responsibility for property damage caused by water
spillage.
• Remove the water tank by grasping the handle and pulling straight up (Fig. 1).
• Lift up on the Motor Housing to remove and set aside (Fig. 2). Remove the Natural Cool
Moisture ® filter from the base before filling the unit with water. Soak in a sink full of cool
water to help reduce mineral build up and place back in the humidifier while wet. DO NOT
SQUEEZE OR WRING OUT THE NATURAL COOL MOISTURE
® FILTER. To help extend the life of
your filter repeat this step each time you fill your humidifier.
• Turn the water tank upside down so that the fill cap is facing up; unscrew the fill cap by
turning it counter-clockwise and set aside.
• Fill the water tank with COOL tap water (Fig. 3). Distilled water is not necessary as the water
is filtered by the Natural Cool Moisture ® filter. DO NOT USE HOT WATER. Doing so may
damage the humidifier.
• Replace the fill cap by turning it clockwise . DO NOT OVER TIGHTEN. Turn the water
tank right-side up.
Fig. 1
W
all
6”
Lift
Fig. 2 Fig. 3
S E T U P
F I L L I N G
HU4085.01 DH-890 E/F/S OM 8/3/01 1:06 PM Page 4