Meinberg GEN170TGP User Manual
Meinberg Hardware
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- Impressum
- The Modular System GEN170TGP
- General Information about DCF77
- GEN170
- GEN170 Overview
- The GEN170 Front Panel Layout
- FAIL LED and LOCK LED
- LC Display
- MENU Key
- CLR/ACK Key
- NEXT Key
- INC Key
- The Menus in Detail
- Root Menu
- Menu SETUP
- SETUP INITIAL TIME
- ADJUST SECONDS
- SETUP TIME ZONE
- SETUP DAYLIGHT SAV ON/OFF
- SETUP LEAP SECOND
- SETUP SERIAL PORT PARM
- SETUP SER. STRING TYPE
- SETUP SERIAL OUTPUT
- SETUP TIMECODE OUT
- INIT USER PARMS
- Resetting Factory Defaults
- Firmware Updates
- Format of the Meinberg Standard Time String
- Time code
- Principle of Operation
- Block Diagram Time code
- IRIG Standard Format
- AFNOR Standard Format
- Assignment of CF Segment in IEEE1344 mode
- Generated Time codes
- Selection of Generated Time Code
- Outputs
- AM Sine Wave Output
- PWM DC Output
- Technical Data
- Technical Specifications GEN170
- Signal Description GEN170
- Rear Connector Pin Assignments GEN170
- DCF77-Simulator
- Function
- Technical Specifications SIM77PV4
- Rear Connector Pin Assignments SIM77PV4
- GEN170TGP Rear view
- Assignments of the 25 pin Connector