Meinberg PZF600 - Manual (Page 38)

38
Signal description PZF600
Name Pin Function
GND 32a+c Reference potential
VCC in (+5V) 1a+c +5V power supply
VDD in (+12V) 2a+c +12V power supply, not used by standard
DCF_MARk out 17c DCF77 emulation, TTL, active high
pulse duration: 100ms or 200ms
P_SEC out 6c Pulse per second, TTL-level, active high
/P_SEC out 6a Pulse per second, TTL-level, active low
P_MIN out 8c Pulse per minute, TTL-level, active high
/P_MIN out 8a Pulse per minute, TTL-level, active low
100kHz out 10a 100kHz frequency output, TTL-level
155kHz out 11c 155kHz frequency output, TTL-level
1MHz out 11a 1MHz frequency output, TTL-level
10MHz out 12a 10MHz frequency output, TTL-level
F_SYNTH out 21c Synthesizer frequency, TTL-level
F_SYNTH_OD out 22c Synthesizer frequency, open-drain
F_SYNTH_SIN out 23c Synthesizer frequency, sinewave
Timecode_AM 14a Timecode, amplitude modulated 1kHz sinewave carrier
Timecode_DC 13a Timecode, TTTL-level, active high
COM0 TxD out 26c COM0 RS-232 output
COM0 RxD in 30c COM0 RS-232 input
COM1 TxD out 24c COM1 RS-232 output
COM1 RxD in 29c COM1 RS-232 input
COM2 TxD out 16a COM2 RS-232 output
COM2 RxD in 15a COM2 RS-232 input
COM3 TxD out 18a COM3 RS-232 output
COM3 RxD in 17a COM3 RS-232 input
/BOOT in 4a Input for activating the bootstrap-loader
TIME_SYN out 19c Status output, TTL-level, high if synchronous
/RESET in 9c Input for external RESET
reserved Reserved for future expansions, do not connect