Metro LEC Drawer Slide Replacement - Manual

®
InterMetro Industries Corporation
North Washington Street, Wilkes-Barre, PA 18705
For Product Information Call: 1-800-433-2232
Visit Our Web Site: www.metro.com
ASSEMBLY
INSTRUCTIONS
LEC Drawer Slide
Replacement
BEFORE ATTACHING DRAWER
SLIDE TO CART:
1. Fully extend drawer slide
assembly as shown (Fig. 1).
3. While slide is still extended, fit the
shoulder rivet on the slide into the
slot in the rear of the upright. Fasten
the mounting screw to the
corresponding hole in the front
upright. Push the slide fully into the
cart. (A slight resistance should
be felt.)
4. Repeat above procedure for other
slide assembly.
4. Unscrew the mounting screw and
lift the slide out of the cart.
5. Install new slide using the
above instructions.
Max. weight capacity of drawer 75 lbs.
Fig. 3
Fig. 2
TO REMOVE (OR REPLACE) A
DRAWER SLIDE FROM THE CART:
1. Remove drawer(s) from cart by
lifting red tabs located near front end
of drawer slide.
2. Fully extend the drawer slide from
the cart.
3. Notice the square hole located
near the front of the slide. To remove
the drawer slide, insert the tip of a
screwdriver between the tab (located
behind the front edge of the square)
and the slide as shown below. Turn
the screwdriver towards the cart
body. This will force the tab away
from the slide and disengage the
stop. This will allow you to further
extend the slide and access the
mounting screw.
ASSEMBLY
INSTRUCTIONS
For LEC Drawer Slide Replacement
Fig. 1
2. Insert a screwdriver into the
opening shown and while turning
the screwdriver force the tab down
until the tab contacts the metal
slide beneath the tab as shown
below (Fig. 2).
L01-237
8/95
Information and specifications are subject to change
without notice. Please confirm at time of order.