Metro Filler Kit - Side to Wall - Manual

Part No. INST-UWFLR
Date: 10/09/01
WORKCENTERS
INSTALLATION
INSTRUCTIONS
Filler Kit - Side to Wall
1. Level base unit in position for installation, remove
wall mounting bracket.
2. Remove filler strips from posts and replace with
supplied plastic post extrusions. See back page.
Trim excess as required.
3. Slide filler extrusions into place as shown on
back page Trim excess as required
4. Cut to length, align and mount the wall mount
extrusions (Qty. 2) to wall. See back page. Wall
mounts can be secured with screws or double-
sided adhesive tape. (Hardware is not included)
5. Align filler extrusion within the slot of the wall-
mounted piece and the plastic extrusion within
the aluminum post. See back page.
6. Reattach wall mounting bracket. Fasten to wall &
attach countertop following the steps outlined in
the Starsys WorkCenters Installation Manual.
(Shipped in each base unit)
Note: Plastic extrusions can be trimmed, punched,
or drilled to accommodate utilities as needed.