Metro Starsys Overbridge Tilt Bin - Manual

INSTALLATION
INSTRUCTIONS
OVERBRIDGE
TILT BIN
Assembly consists of (1) Tilt Out Bin Assembly, (2) Mounting Brackets, (1) Hardware Bag consisting
of (6) Mounting Screws and (2) Nylon Lock Nuts.
1. Insert the (2) #10-24 x 1/2" Phillips round HD screws into the outboard slots of the brackets and install
nylon lock nuts. Tighten until a gap of approximately 1/4" is between the head and bracket.
2. Position the (2) mounting brackets at the desired locations on the overbridge by aligning the mounting
holes with the inserts. Secure the mounting brackets with the (4) #10-24 x 1/2" Phillips truss HD screws
as shown.
3. Align the (2) keyhole slots on the rear of the tilt out bin with screw heads. Slide the tilt bin down over the
screw head to lock in place. Tighten screws.
INST-SXRBIN
11/12
Part No. SXRMF543/544/546
FRONT OF CART
Tilt Out Bin
Keyhole
Slot (Typ.)
Mounting
Bracket (Typ.)
Threaded Insert in Rear
of Overbridge (Typ.)
(4) #10-24 x 1/2" Phillips
Truss Head Screw (Typ.)
(2) #10-24 x 1/2" Phillips
Round Head Screw (Typ.)
Overbridge
(2) #10-24 Nylon
Lock Hex Nut (Typ.)