MK Products Prince XL LE Com ACWC - Manual (Page 14)

Prince ® XL Lincoln Compatible Gun Owner's Manual - Page 7
Snake Skin Cover 13ft (for 15ft leads)......................................... 931-0110
Snake Skin Cover 23ft (for 25ft leads)......................................... 931-0122
Snake Skin Cover 33ft (for 35ft leads) ........................................ 931-0132
Snake Skin Cover 48ft (for 50ft leads) ........................................ 931-0123
Gas Valve Removal Tool
Gas valve removal is often required to replace the standard valve stem with
a modified valve stem (P/N 431-1080) when placing an older model gun on
a newer model wire feeder. This is performed by using P/N 931-0105 Gas
Valve Removal Tool. This multifunctional tool has been slotted on one side
to encompass and conform to the gas valve stem and seat into the slotted
gas valve body as seen in Figures 1 and 2. Removal of the gas valve can be
accomplished by turning the gas valve tool counter clockwise. Reinstall by
turning clockwise. The tool doubles as a bottle opener.
Section D Maintenance
Maintenance of the gun will normally consist of a general cleaning of the wire
guide system, including tubes, drive rolls, and conduit at regular intervals.
Remove spatter build-up from inside of nozzles with a hardwood stick.
The only parts on the gun that are subject to normal wear are the conduit,
contact tips, gas cups, drive and idler rolls and barrel liners. A supply of
those parts should be maintained on hand.
If repairs do become necessary, qualified shop maintenance personnel can
easily replace any parts.
Your Cobramatic
® System is designed to provide years of reliable service.
Normal wear and component failure may require occasional service.
The number of units in operation and the importance of minimal “down time”
will determine to what extent spare parts should be stocked on hand. See
the “Recommended Spare Parts List” for the most commonly replaced parts.
Maintenance Tools
Tool Part Number
Gas Valve Removal Tool 931-0105
Contact Tip Removal Tool 931-0044
Drive Roll Removal Tool 931-0100
Idler Roll
005-0686
Micro Switch Assy (switch with leads)
003-0568
Figure 2 Gas Valve Removal Tool Figure 1
Drive Roll
511-0101
Recommended Spart Parts List
Part Number Description
615-0620-6 Conduit 6’
615-0620-15 Conduit 15’
615-0620-25 Conduit 25’
615-0620-35 Conduit 35’
615-0620-50 Conduit 50’
005-0661 Potentiometer Kit
003-0568 Micro Switch
005-0633 Handle Kit
511-0101 Drive Roll
005-0686 Idler Roll Kit
325-0206 Idler Roll Screw
333-0082 Idler Roll Washer
003-0585 Trigger Assy.
431-3117 Door