Monster PRO 600 - Manual (Page 7)

6 7
PRO 600 POWeRCenTeR feaTURes
1. “On/Off” switch: Turns ON/OFF the outlets .
2. “breaker 15a-Press to Reset”: When the thermal circuit breaker tripped due to overload, to protect
your equipment, find the reason for overload, correct it and press the breaker in to reset .
3. Convenience Outlet: This outlet is located on the front of the PowerCenter for easy access .
This outlet has a specially designed filter circuit for high current audio components .
4. High Current filter: These outlets have a specifically designed filter circuit that reduces interference
to your analog components .
5. Ground Terminal: Provides a ground reference point for any ungrounded components .
6. High Current Powerline 100 aC Power Cable: High density AC power cord specially designed
to maximize power transfers .
TROUblesHOOTInG
symptom Possible Cause Remedy
The PowerCenter is not
receiving power . The PowerCenter
is not turned On . • Turn the PowerCenter switch on.
• Make sure the PowerCenter’s AC power plug
is plugged into a properly grounded 120 volts
(nominal) wall outlet .
• In some households, a wall switch may need
to be thrown to make the wall plug active .
Try turning on the light switches located near
the wall unit .
Too many devices are
connected, causing
an overload, tripping
the Thermal Circuit Breaker . • Press the PowerCenter Thermal Circuit Breaker
button in to reset . Please allow 10 minutes
before attempting to reset . If you reset too
soon, the breaker will prematurely sense
power overload and not allow unit to operate .
• If the Circuit Breaker continues to trip, try
moving one or more components to another
PowerCenter . You may be drawing too much
current through one PowerCenter .