Montigo Flush Face (DF) - Manual (Page 3)

Page 3
introduCtion:
This Planning guide is intended to assist the Architect, designer, builder and homeowner
when choosing the most appropriate installation type and location for your new Montigo Flush
Face Direct Vent fireplace.
This guide is not intended to substitute for the Montigo Installation guide for the gas fireplace of
choice. The Operation and Maintenance Manual designed for your Direct Vent fireplace should
be followed without exception. For a listing of all Montigo Direct Vent fireplaces, see;
www.montigo.com/products.html
BEForE you BEgin:
The Flush Face Direct Vent fireplace is a vented heating appliance. It must be installed by
a qualified installer . If you have not yet contacted with an installer this would be a perfect time to
do so. You can see all the installers for your State, or Province, at;
www.montigo.com/dealer.html
What iS a dirECt VEnt ?:
The Flush Face Direct Vent fireplace is listed as 'Direct vent' fireplace. This description
means that all the air for combustion comes directly from the outside atmosphere and all flue
gasses are discharged directly to the outside atmosphere.
What iS in thE Box ?:
The Flush Face Direct Vent fireplace currently ships with; one box of glass beads, or two
for See-thru models (Linear Burner models only), one nailing flange extension, and one door
opener tool. The fireplace can also be turned on/off via a switch supplied by your installer, or
order the optional remote control.
Note: Read the installation / operation instructions for your specific Montigo Direct Vent
fireplace. Vent pipe must also be ordered separately through your retailer or Montigo.