Montigo PF2RK - Manual (Page 4)

Installation
Page 4
XT0021 - 092214
D. Operation with Main Power:
1. Follow the instructions on the
"Proflame2 Operation and Mainte-
nance Manual- XG0677" to install batteries on the remote control.
2. Turn the gas supply ON.
3. Turn the Main Power to ON.
4. Program the remote control to the control module
(see "Proflame2
Operation and Maintenance Manual- XG0677").
5. Turn the fireplace ON and modulate the flame using the remote control
and ensure proper operation (see "Proflame 2 Operation and Main-
tenance Manual XG0677").
E. Battery Holder Installation:
1. Secure the battery holder to the fireplace floor using the supplied
velcro strips. See Figure 9.
Note: The velcro strips act as an electrical isolation, do not attach
the battery holder to any metal part without using the velcro strips, or
the control module will be damaged.
2. Connect the red and black wires from the battery holder to the
red and black wires from the valve harness. See Figure 10 .
Figure 8 Attach switch to bracket
Figure 9 Battery holder
F. Operation with Backup Battery:
1. Install the four supplied AA batteries to the battery holder.
CAUTION: Please note battery orientation while installing them.
Incorrect orientation may damage battery, cause fire hazard and the
fireplace may not function properly.
2. Follow the instructions on the "Proflame2 Operation and Main-
tenance Manual- XG0677" to install batteries on the remote
control.
3. Turn the gas supply ON.
4. Program the remote control to the control module
(see "Pro-
flame2 Operation and Maintenance Manual- XG0677").
5. Check the stepper motor for gas leaks and ensure no leak.
6. Turn the fireplace ON and modulate the flame using the remote
control and ensure proper operation (see "Proflame 2 Opera-
tion and Maintenance Manual XG0677").
Blue Back lit LCD display
On/Off Key
Thermostat Key
Up/Down Arrow Key
Mode Key
Figure 10 Battery holder wires
Figure 11 Proflame Remote Control