Montigo MD34 BV - Manual (Page 7)

Page  XG0305
MD34-BV Homefire
Installation
Removing and Installing
the Insert
You may remove the insert to protect it from theft and damage dur-
ing construction.
1. Remove the two machine screws (1 left & 1 right) at the top of the
insert that attach the insert to the shell. See Inset 1.
2. Remove the fresh air flex from the collars on the shell. See Figure
9. Important: Be careful not to damage the fresh air flex dur-
ing removal or storage.
3. Remove the 4 machine screws that hold the venting plate to the
insert.
4. Remove the insert by tipping the top of the insert outward and lift-
ing the tabs past the slots in the bottom of the shell. See Inset 2.
Store the screws and clamps in a safe place to ensure that they are
not lost.
To re-install the insert simply reverse the steps above.
Figure 9. MD34-BV insert.
INSET 1
Tab
INSET 2
Mounting
Bracket
Venting Plate
Front
Slot
Removing and Installing
the Door
Removing the door surround:
The door surround is held in place by two metal clips at the top, and
one magnet on each side. To remove the surround, pull the bottom
outwards and lift upwards until the slots "A" are clear of tabs "B" in
the door. You may need to use a flat screwdriver to pull the door sur-
round outwards.
(See figure 10a).
Removing the door:
Remove the machine screws along the top of the door, and then pull
the door outwards and upwards until it is clear of the door rail.
(See
figure 10b). Ensure that a good seal is maintained when installing the
door.
Glass door
and frame
Door surround
Tab 'B'
Slot 'A'
Magnet
Pull bottom of door
surround outwards
and upwards.
Figure 10b. Removing or installing the glass door.
Machine Screws
Door Rail Tabs Glass door
& frame
Figure 10a. Removing or installing the door surround.