Safety 1st Alpha Omega Elite - Manual (Page 26)

48
5
4
Fit loops on harness ends
onto the harness bracket.
Pull harness through the
back. Make sure the
harness goes OVER the
headrest adjustment bar.
WARNING !
Reinstall Base:
Remove bar from base.
Line up shell with base.
Begin with the rounded
end, push bar completely
through hole, starting on
the right side
(A) , until it
locks in place. Refer to
“Removal of Seat Base”.
6
A
From bottom of shell,
release the elastic straps at
the bottom of seat and
the large elastic straps on
the side of seat.
Adjust backrest to lowest
position. Remove both
lower harness guides
(A)
in bottom of seat under
recline stand.
Push harness guide lip
toward outside of shell
with one hand while
pulling harness guide from
the front with the other.
A
1
2
Remove Seat Pad for Cleaning
Remove base and harness as described in the
“Belt-Positioning Booster” section.
Upper Harness Guides
Lower Harness Guides
49
Failure to place harness over the metal bar
of the harness/headrest adjuster in back
can result in serious injury or death.
4358-3340A Instrctions 11/15/04 9:18 AM Page 51