MovinCool Condenser Air Plenum - Manual

Unplug the unit from the
receptacle.
Remove the filter frame as-
sembly from the condenser
side panel by lifting it up
and tilting outward at the bottom
as indicated by the arrows above.
Remove the filter element
from the filter frame by
pressing inward on the re-
tainer at the indicated points (A),
then, opening the retainer (B).
(Save the filter frame for future use)
Temporarily remove the left
lower three (3) screws from
the rear panel of the unit.
Turn the latch of the Air
Plenum counterclockwise
until it stops. Place the Air
Plenum over the condenser
opening and align the hinge/
bracket assembly mounting holes
with the respective screw holes
on the back of the unit.
For ease of installation, turn
the latch to the full clock-
wise position. (This will hold
the front part of the Plenum onto
the unit). Attach the hinge/
bracket of the Air Plenum to the
rear of the unit using the original
three (3) screws that were tem-
porarily removed in step 5.
Move the unit to an open
area with enough room for
the installation process.
Open the Air Plenum by
turning latch counterclock-
wise and install the air filter
element (from the filter frame)
onto the Air Plenum (as indi-
cated).
9 Close and secure the Air
Plenum to the unit.
The unit is now ready for use.
Classic 10 Air Plenum Installation
CAREFULLY READ INSTRUCTIONS FOR CORRECT INSTALLATION AND USAGE.
© 2000 DENSO SALES CALIFORNIA, INC.
DENSO P/N: LA990009-1261
www.movincool.com
Air Plenum Kit Part Number:
LAY84270-0040
1
2
3 4 5
6 7 8
A
B