Mr. Coffee BMX4 - Manual (Page 9)

THE GRIND SETTING
KNOB DOES NOT TURN
THE UNIT STOPS
GRINDING
THE TIMER KNOB DOES
NOT TURN
1. Timer setting is incorrect
2. Timer was inadvertently
rotated to OFF
3. Hopper lid has been opened
4. Ground coffee chamber is
not in correct position
5. Cancel button has been
pressed
6. The unit has been
unplugged
7. There’s a power outage
8. Ground coffee chamber is
full and is clogging the burr
mill compartment
9. Motor has overheated,
thermal fuse is broken
SET TIMER CORRECTLY
SET TIMER CORRECTLY
CLOSE HOPPER LID
PLACE CHAMBER IN
PROPER POSITION
PRESS START BUTTON
AGAIN
PLUG UNIT IN
WAIT FOR POWER TO BE
RESTORED
REMOVE CHAMBER,
EMPTY AND REPLACE;
UNPLUG UNIT AND
CLEAN BURR MILL
COMPARTMENT IF
NEEDED
CALL AUTHORIZED
SUNBEAM SERVICE
CENTER
PROBLEM POSSIBLE CAUSE SOLUTION
TURN
COUNTERCLOCKWISE
TO SET DESIRED
NUMBER OF CUPS
TURN CLOCKWISE TO
SET DESIRED NUMBER
OF CUPS
CALL AUTHORIZED
SUNBEAM SERVICE
CENTER
1. Timer is at OFF setting,
cannot turn clockwise
anymore
2. Timer is at 12 setting,
cannot turn
counterclockwise anymore
3. Timer knob is broken
1. Knob is at the Fine (A)
Setting, cannot turn clockwise
anymore
2. Knob is at the Coarse (E)
Setting, cannot turn
counterclockwise anymore
3. Unit and burr mill are not
clean
4. There’s a foreign object
between the two burr mills
TURN
COUNTERCLOCKWISE
FOR DESIRED GRIND
SETTING
TURN CLOCKWISE FOR
DESIRED GRIND SETTING
CLEAN UNIT, UNPLUG IT
AND CLEAN BURR MILL
UNPLUG UNIT AND
CAREFULLY DISLODGE
FOREIGN OBJECT
CONT.